1 |
# /etc/conf.d/net.eth0 - example eth0 network device configuration |
# /etc/conf.d/net.eth0 - example eth0 network device configuration |
2 |
# $Header: /home/cvsd/magellan-cvs/magellan-src/magellan-initscripts/etc/conf.d/net.sample,v 1.1 2007-09-30 10:36:10 niro Exp $ |
# $Header: /home/cvsd/magellan-cvs/magellan-src/magellan-initscripts/etc/conf.d/net.sample,v 1.2 2007-12-13 12:05:38 niro Exp $ |
3 |
|
|
4 |
# Enable this device automatically on system boot. |
# Enable this device automatically on system boot. |
5 |
# If set to anything but ?yes? the NIC will be ignored by |
# If set to anything but ?yes? the NIC will be ignored by |
85 |
# Encryption key in ascii (or use hex key) |
# Encryption key in ascii (or use hex key) |
86 |
#WIRELESS_KEY_ASCII |
#WIRELESS_KEY_ASCII |
87 |
# driver used for wpa_supplicant |
# driver used for wpa_supplicant |
88 |
# WIRELESS_WPA_DRIVER=zydas |
#WIRELESS_WPA_DRIVER=zydas |
89 |
|
|
90 |
|
|
91 |
# |
# |
93 |
# |
# |
94 |
# Note: to setup a bridge this file must be called net.br[0-9] |
# Note: to setup a bridge this file must be called net.br[0-9] |
95 |
# |
# |
96 |
# Interface to which the bridge shall point to |
# Interfaces to which the bridge shall point to |
97 |
#BRIDGE_INTERFACE="eth0" |
# It is possible to give more then on |
98 |
|
#BRIDGE_INTERFACES="eth0 eth1" |
99 |
|
# Enables or disables Spanning Tree |
100 |
|
# Possible values are 'on' and 'off' |
101 |
|
#BRIDGE_STP="on" |
102 |
|
# |
103 |
# Here comes the same settings like with normal NICs |
# Here comes the same settings like with normal NICs |
104 |
# A static example: |
# A static example: |
105 |
#NETWORKING="static" |
#NETWORKING="static" |